BodyCraft BCG-GX - Manual (Page 15)

14
STEP 8 INSTALL LOWER CABLE
1. Route the steel ball end of the Lower cable (89) under Pulley L1 mounted at the front of the Low Pull
Station using one 3/8" X 1-3/4" Hex Bolt (101) and one 3/8" Nylon Nut (124).
2. Continue back to Pulley L2 mounted on the Base Frame (1) using one 3/8" X 1-3/4" Hex Bolt (101) and
one 3/8" Nylon Nut (124). Route the cable underneath L2 and then up to Pulley L3 mounted in bottom
of the Double Pulley Block (19) using one 3/8" X 1-3/4" Hex Bolt (101) and one 3/8" Nylon Nut (124).
3. Continue down to Pulley L4 mounted to the Base Frame (1) using one 3/8" X 1-3/4" Hex Bolt (101) and
one 3/8" Nylon Nut (124).
4. Route the cable underneath L4 and Pulley L5 mounted in the slot in the bottom of the Front Upright (3)
using one 3/8" X 3" Hex Bolt (99), two 3/8" washers (116), two 3/8" ID Bushings (77), and one 3/8"
Nylon Nut (124).
5. Connect the steel ball end of the cable to the receptor bracket L6 welded to the Leg Extension Arm (10).