Document Outline

• Your new washing machine
• Display rules
• Contents
  • en Instruction Manual and Installation Instructions
    • 8 Intended use 4
    • ( Safety instructions 5
    • 7 Environmental protection 7
    • * Getting to know the appliance 8
    • Z Laundry 10
    • C Detergent 11
    • 0 Programme default settings 12
    • \ Additional programme settings 13
    • 1 Operating the appliance 14
    • H Sensors 18
    • M Setting the signal 19
    • 2 Cleaning and maintenance 20
    • 3 Faults and what to do about them. 22
    • 4 After-sales service 25
    • J Technical data 26
    • 5 Positioning and connecting 26
  • 8 Intended use
    • Intended use
    • ( Safety instructions
      • Safety instructions
      • Electrical safety
• : Warning
  • Danger of death!
  • Risk of injury
• : Warning
  • Risk of injury!
• : Warning
  • Risk of scalding!
  • Safety for children
• : Warning
  • Danger of death!
• : Warning
  • Danger of death!
• : Warning
  • Risk of suffocation!
• : Warning
  • Risk of poisoning!
• : Warning
  • Eye/skin irritation!
• : Warning
  • Risk of injury!
  • 7 Environmental protection
    • Environmental protection
    • Packaging/used appliance
    • Tips on economical use
  • * Getting to know the appliance
    • Getting to know the appliance
    • Washing machine
    • Control panel
      • Note:
    • Display panel
      • Note:
      • Setting options and information for the selected programme
      • Symbols for the programme sequence and information
  • Z Laundry
    • Laundry
    • Prepare the laundry
      • Caution!
      • Damage to the appliance/fabrics
    • Sorting laundry
      • Note:
    • Starching
      • Note:
    • Dyeing/bleaching
    • Soaking
      • 1. Pour soaking agent/detergent into compartment II according to the manufacturer’s instructions.
      • 2. Turn the programme selector to the Cottons 30 °C programme.
      • 3. Press the start button.
      • 4. After approx. 10 minutes, press the start button again to pause the programme.
      • 5. After the required soaking time, press the start button again, if the programme is to be continued or changed.
      • Notes
  • C Detergent
    • Detergent
    • Correct selection of detergent
    • Saving energy and detergent
      • Saving
      • Soiling/note
      • Note:
  • 0 Programme default settings
    • Programme default settings
    • Note:
    • Temperature
    • Spin speed
    • Ready in time
      • 1. Select the required programme.
      • Note:
        • 2. Press the Ready in button repeatedly until the required number of hours is displayed in the display panel.
        • 3. Press the Start button.
        • 1. Press the Start button.
        • 2. YES and v lights up in the display panel. The washing machine door can be opened and laundry can be added.
        • 3. Close the washing machine door.
        • 4. Press the Start button again. The preselected time continues to run.
  • \ Additional programme settings
    • Additional programme settings
    • Note:
    • SpeedPerfect (
      • Note:
    • EcoPerfect à
      • Note:
    • Rinse Plus
    • Water Plus
    • Easy Iron
  • 1 Operating the appliance
    • Operating the appliance
    • Preparing the washing machine
      • Note:
        • 1. Plug in the mains plug.
        • 2. Turn the tap on.
        • 3. Open the washing machine door.
        • 4. Check that the drum is completely drained. Drain if necessary.
    • Select programme/switch on the appliance
      • Note:
    • Change the programme default settings
    • Placing laundry into the drum
• : Warning
  • Risk of death!
    • Notes
      • 1. Unfold presorted items of laundry before placing them in the washing drum.
      • 2. Make sure that no items of laundry are trapped between the washing machine door and the rubber seal, and close the door.
  • Measure and add detergent and care products
    • Caution!
    • Damage to the appliance
• : Warning
  • Eye/skin irritation!
    • Note:
      • 1. Pull out the detergent drawer as far as possible.
      • 2. Add detergent and/or care products.
      • 3. Close the detergent drawer.
      • 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
      • 2. Slide the measuring aid forwards, fold it down and click it into place.
      • 3. Reinsert the drawer.
    • Note:
  • Start the programme
    • Note:
  • Childproof lock
    • Note:
  • Adding laundry
    • 1. Press the Start button to pause the programme.
    • Note:
      • 2. To continue the programme, press the Start button.
  • Changing the programme
    • 1. Press the Start button to pause the programme.
    • 2. Select a different programme.
    • 3. Press the Start button again . The new programme starts from the beginning.
  • Cancel the programme
    • 1. Press the Start button to cancel the programme.
    • 2. To cool the laundry: Set the programme to Rinse.
    • 3. Press the Start button again. The rinse programme starts.
  • Programme end
    • Note:
  • Removing laundry/switching off the appliance
    • 1. Open the washing machine door and remove the laundry.
    • Notes
      • 2. Set the programme selector to the Off position. The appliance is switched off.
      • 3. Turn off the tap.
    • Note:
    • Notes
  • H Sensors
    • Sensors
    • Automatic load sensing
    • Unbalanced load detection system
      • Note:
  • M Setting the signal
    • Setting the signal
    • 1. Set the button and information signals
    • 2. Set the volume for button signals
    • 3. Set the volume for the information signals
  • 2 Cleaning and maintenance
    • Cleaning and maintenance
• : Warning
  • Danger of death!
• : Warning
  • Risk of poisoning!
    • Caution!
    • Damage to the appliance
  • Machine housing/control panel
  • Drum
  • Descaling
  • Detergent drawer and housing
    • 1. Pull out the detergent drawer. Press down the insert and fully remove the drawer.
    • 2. To remove the insert: Push the insert upwards from below with your finger.
    • 3. Clean the detergent dispenser tray and insert with water and a brush, and dry it. Clean the inside of the housing as well.
    • 4. Fit the insert and lock it in place (push the cylinder onto the guide pin).
    • 5. Push in the detergent drawer.
    • Note:
  • Detergent solution pump blocked
• : Warning
  • Risk of scalding!
    • 1. Turn off the water tap so that no more water can flow in and has to be drained via the detergent solution pump.
    • 2. Switch off the appliance and pull out the mains plug.
    • 3. Open and remove the service flap.
    • 4. Fold out the water gutter in front of the pump cover.
    • 5.
    • 6. Now carefully unscrew the pump cover. Residual water may run out.
    • 7. Fold in the water gutter.
    • 8. Place the service flap back on, lock it into place, and close it.
    • Note:
  • The drain hose at the siphon is blocked
    • 1. Switch off the appliance. Disconnect the mains plug.
    • 2. Loosen the hose clamp. Carefully remove the drain hose, residual water may leak out.
    • 3. Clean the drainage hose and siphon connecting piece.
    • 4. Reattach the drainage hose and secure the connection using the hose clamp.
  • Filter in the water supply blocked
    • 1. Turn off the tap.
    • 2. Select any programme (except Rinse, Spin, Empty.
    • 3. Press the Start button. Allow the programme to run for approximately 40 seconds.
    • 4. Set the programme selector to the Off position. Remove the mains plug.
    • 5. Clean the filter on the water tap:
    • 6. For standard and Aqua-Secure models, clean the filter on the rear of the appliance:
    • 7. Connect the hose and check for leaks.
  • 3 Faults and what to do about them.
    • Faults and what to do about them.
    • Emergency release
• : Warning
  • Risk of scalding!
• : Warning
  • Risk of injury!
    • Caution!
    • Water damage
      • 1. Set the programme selector to the Off position. Remove the mains plug.
      • 2. Drain the water.
  • Information on the display panel
    • Display
    • Cause/remedial action
  • Faults and what to do about them.
    • Faults
    • Cause/remedial action
  • 4 After-sales service
    • After-sales service
  • J Technical data
    • Technical data
  • 5 Positioning and connecting
    • Positioning and connecting
    • Included with the appliance
      • Note:
    • Safety instructions
• : Warning
  • Risk of injury!
    • Caution!
    • Damage to the appliance
    • Caution!
    • Water damage
    • Notes
  • Installation surface
    • Note:
  • Installation on a base or a wooden joist floor
    • Caution!
    • Damage to the appliance
    • Note:
  • Installation on a platform with drawer
  • Installing the appliance in a kitchenette
• : Warning
  • Risk of death!
    • Notes
  • Removing the transport locks
    • Caution!
    • Damage to the appliance
    • Note:
      • 1. Take the hoses out of the holders.
      • 2. Unscrew and remove the bolts from all four transport safety devices.
      • 3. Insert the covers.
  • Hose and cable lengths
    • Tip:
  • Water inlet
• : Warning
  • Risk of death!
    • Notes
    • Note:
    • Note:
    • Note:
  • Water outlet
    • Caution!
    • Water damage
    • Note:
      • : Warning
      • Risk of scalding!
      • Caution!
      • Damage to the appliance/fabrics
  • Levelling
    • 1. Loosen the lock nuts using a wrench, by turning it in a clockwise direction.
    • 2. Check the alignment of the washing machine with a spirit level, and adjust it if necessary. Change the height by turning the appliance feet.
    • 3. Tighten the lock nut against the housing.
  • Electrical connection
• : Warning
  • Danger of death!
    • Notes
  • Before washing for the first time
    • Notes
      • 1. Check the machine.
      • 2. Plug in the mains plug.
      • 3. Turn the tap on.
      • 4. Close the washing machine door (do not load any laundry).
      • 5. Select the Cottons programme and 90 °C as the temperature.
      • 6. Open the detergent drawer.
      • 7. Pour approx. 2 litre of water into compartment II.
      • 8. Pour standard detergent into compartment II.
      • Note:
        • 9. Close the detergent drawer.
        • 10. Press the Start button.
        • 11. When the programme ends, switch off the appliance.
  • Transportation
    • 1. Turn off the water tap.
    • 2. Reduce the water pressure in the supply hose.
    • 3. Drain the remaining detergent solution.
    • 4. Disconnect the washing machine from the mains.
    • 5. Remove the hoses.
    • 1. Remove the covers and keep in a safe place.
    • 2. Insert all four sleeves.
    • Notes
      • 1. If water damage is caused due to a fault in our Aqua-Stop system, we will compensate domestic customers for the damage caused.
      • 2. The liability guarantee is valid for the service life of the appliance.
      • 3. It is a prerequisite of all warranty claims that the appliance with Aqua-Stop must have been installed and connected correctly in accordance with our instructions; this also includes a correctly fitted Aqua-Stop extension (genuine accessories).
      • 4. Appliances with Aqua-Stop do not need to be supervised during operation, nor secured afterwards by turning off the tap.