Bernina Happy Voyager - Manual (Page 43)

Happy Voyager
Removing Unwanted Jump Stitches 20
Explanation of Issue:
If cut at jump data is set to “0” , no stitches will be
cut . (The thread cuts between the different color
changes is not effected.)
Note: While jumping between to————-be the
needle bar is disengage and causes a loud clank-
ing noise!
Explanation of Issue:
If cut at jump data is set to “3” , which is the de-
fault setting. All stitches with more then 3 jumps
will be cut, those with less then 3 will not be cut.
Jump stitch