Philips Freidora - Manual (Page 12)

Problem Cause Solution
Steam escapes
from other places
than the filter.
You may not have placed
the lid properly on the
appliance.
Place the lid properly on the appliance.
The permanent anti-
grease filter is saturated.
Remove the lid and clean the lid and the filter in
hot water with some washing-up liquid or in the
dishwasher.
Oil or fat spills
over the edge of
the fryer during
frying.
There is too much oil or
fat in the fryer.
Make sure the oil or fat in the fryer does not
exceed the MAX indication.
The food contains too
much moisture.
Dry the food thoroughly before you fry it and
fry the food according to the instructions in this
user manual.
There is too much food in
the frying basket.
Do not fry more food at one time than the
quantity mentioned in the food table at the end
of this booklet.
The oil or fat
foams strongly
during frying.
The food contains too
much moisture.
Dry the food thoroughly before you fry it.
The type of oil or fat used
is unsuitable for deep-
frying food.
Use frying oil or liquid frying fat that is suitable
for deep-frying food. Never mix different types
of oil or fat.
You have not cleaned
the inner bowl properly.
Clean the inner bowl as described in this
user manual.
The fryer does
not work.
You have not switched on
the fryer.
Set the on/off switch to ‘I’ to switch on the fryer.
You have not placed the
control panel properly.
Make sure the control panel is placed correctly.
You hear a click when the control panel locks
into position.
The safety cut-out has
switched off the appliance.
The fuse of the temperature control may have
blown, causing the safety cut-out to switch off
the appliance. Carefully press the reset button
at the back of the control panel with a small
screwdriver. Now the appliance is ready for
use again.
If pressing the reset button does not help, go to
your Philips dealer or a service centre authorised
by Philips.
Food table (Fig. 18)
EnglisH 14