Beyonwiz FV-L1 - Manual (Page 39)

Quick Setup
32
2) Manual Configuration
If you set “DHCP” to “Disable”, you must input the network settings
manually. Use the NUMERIC and LEFT/RIGHT buttons to configure
the following items;
 IP Address: enter a 12-digit IP address.
 Subnet Mask: enter a 12-digit subnet mask.

Gateway: enter a 12-digit gateway.

Primary DNS Server IP: enter a 12-digit primary DNS server IP
address.
 Secondary DNS Server IP: enter a 12-digit secondary DNS server IP
address.
Then press the RED button to update the LAN settings. A “LAN Status”
pop-up window will now appear to show you the updated LAN settings.
Press EXIT to close the “LAN Status” pop-up window
NOTE

If an address you need to input does not have 12 digits, use
preceding 0s to make it 12 digits in length e.g. an address of
“192.168.0.1” must be entered as “192.168.000.001”.

The MAC Address setting will display the MAC address of the Ethernet
interface, but you cannot change it.
 You can also press the GREEN button to open the “LAN Status” pop-
up window to check your settings.

If you change the DHCP setting to “Enable”, the manual settings no
longer apply, however they will still display the previously set
configuration values.