Beyonwiz FV-L1 - Manual (Page 61)

STB & PVR Function
54
5) Power Off during Recording
If you attempt to put the FV-L1 into standby mode while a recording is
in progress, a “Power Off” dialog will be displayed, as shown below.
You can then choose from the following options;

Later: the FV-L1 will return to standby mode when the current
recording(s) have completed.

Yes: the current recording(s) are stopped and the FV-L1 goes into
standby mode immediately.
 No: the standby mode procedure is cancelled and the FV-L1 remains
on.
Use the LEFT/RIGHT buttons to select your desired option and press
OK.
If a timer starts while the FV-L1 is in standby mode, the FV-L1 will turn
on automatically and perform its operation until the timer has
completed. If remote control activity is detected during this period, the
FV-L1 will remain on so you can continue to use it without interruption,
otherwise it will return to standby mode.
NOTE

If AC power is not supplied to the FV-L1 properly (e.g. a power
blackout), it cannot perform a timer recording. If a timer fails due to
this reason, this timer remains in the timer list as notification.
 If AC power is restored within a timer’s duration, the timer will
become active immediately and recording will begin.

If AC power is not supplied for a long period i.e. several hours, the
internal clock of the FV-L1 will lose it’s time setting, and all timers will
fail until the time setting is restored (see “Time Setting” section in
Chapter 4).
 If you do not respond to the “Power Off” pop-up dialog, the FV-L1 will
behave as if you selected “Later”, and return to standby mode when
the recording is finished