Barco DICOM THEATER MGP 15 - Manual (Page 16)

Introduction
16
4. Connect the I-Guard optical sensor to a free PC USB
downstream connector. If the cable is not long enough, you
have to use a USB booster/extender.
Installation of the sensor is described more in detail in the
section “MediCal and Dicom Theater software installation
and usage”.
b) Single-head with two projectors
Figure 2
Proceed as follows:
1. Connect one PC video output to the first projector BNC input
by means of the DVI-to-5 BNC cable (15 m / 50 ft).
2. Connect the other video output to the second projector BNC
input by means of the DVI-to-5 BNC cable (15 m / 50 ft).
3. Connect a free PC COM port to the first projector RS-232
connector by means of a D-Sub9-to-D-Sub9 cable (15 m / 50
ft).
VIDEO
RS-232
VIDEO
RS-232
VIDEO
RS-232
USB
RS-232
USB
Video
Video
USB
RS-232