Barco DICOM THEATER MGP 15 - Manual (Page 65)

Barco DPMS Screen Saver
65
Barco DPMS Screen Saver
Introduction
The Barco DPMS (Display Power Management Signaling) Screen
Saver allows the user to set power and display saving features
for medical displays controlled by BarcoMed display controllers.
At the end of the work day, the display will enter certain DPMS
states as requested by the display controller.
Note: The Barco DPMS Screen Saver will not control any displays
connected to a non-Barco display controller.
The default state for the Barco DPMS Screen Saver is the Off
state. In addition to simply entering the Off state after the work
day, the user can specify that the display first go through two
other DPMS Screen Saver states before going into Off state.
These two other states for the Screen Saver are Stand-By and
Suspend. The user can specify how much time should be spent in
each state in the “Amount of Time in each DPMS Power State”
section.
The Barco DPMS Screen Saver can also be used when no one is
logged on.
Barco DPMS Screen Saver Options
From the “Barco DPMS Screen Saver Control Panel” you can
change many DPMS screen saver elements simultaneously. The
DPMS screen saver elements in each scheme are work schedule,
work day screen saver, DPMS settings after work day, and many
additional options.
Current Scheme
Lists the three “DEFAULT” schemes which you can use as they
are. Or you can modify them to meet your office’s schedule.