Barco DICOM THEATER MGP 15 - Manual (Page 95)

95
Windows 2000 display resolution
Tip: These instructions apply to both Windows
®
2000 and
Windows
®
XP.
Setting the resolution of your Dicom Theater display
In order to set the resolution of your Dicom Theater display you
must be logged in using an account with administrator privileges.
1. To set the resolution of your Dicom Theater display(s) right
click on the desktop and select “Properties”.
2. Select the “Settings” tab.
3. Select the rectangle that represents the first Dicom Theater
display attached to the BarcoMed 2MP2CP display controller
you are working with.
NOTE: If you are using the VGA capabilities of your
BarcoMed 2MP2CP display controller, the resolution for the
first display may be set to a VGA resolution of “640 x 480”
pixels with 16 colors and a default refresh rate. If your
BarcoMed 2MP2CP controller is not running VGA, the display
may not be enabled yet. To enable the display, check the
“Extend my Windows desktop onto this monitor” checkbox,
but do NOT click the “Apply” button at this time.
4. Select the “Adapter” tab and then click on the “List All
Modes” button. Select the resolution and refresh rate that
your Dicom Theater display supports from the dialog box and
click “OK”.
5. Click “OK” on the bottom of the Adapter Control Panel. If the
“OK” button on the bottom of the Adapter Control Panel is
not visible, press the “TAB” key once and then press
“CTRL”+“Enter” to select “OK”.
6. Click “OK” in the “Windows will now apply your new
desktop settings” dialog box. Your Dicom Theater display
should now synchronize and display the Windows desktop.