Barco DICOM THEATER MGP 15 - Manual (Page 73)

Barco DPMS Screen Saver
73
and run the BarcoMed Product Install Wizard (please see the
section Software Installation for complete instructions).
Special Note: Reinstalling the Barco DPMS Screen Saver will over
write the DPMS configuration settings and you will need to
reconfigure the DPMS settings on your system.
Uninstalling Barco DPMS
To remove the Barco DPMS Screen Saver from your system insert
the Dicom Theater Software CD in the appropriate device on your
computer, run the BarcoMed Product Install Wizard and follow
these steps.
1. Select only the DPMS Screen Saver on the BarcoMed Product
Install Wizard’s welcome screen and click “Install”.
2. Click “Next” on the Welcome Screen of the Barco DPMS
InstallShield ® Wizard to begin the installation.
3. Select the radio button next to “Remove” on the Program
Maintenance screen of the Wizard and click “Next”.
4. Click “Remove” on the Remove Program Screen of the
Wizard (figure 27 below).
Figure 27