Bissell 3750 SERIES-220-240V EN - Manual (Page 6)

Combination
Tool
Telescoping
Wand
Crevice Tool
TurboBrush ™
Attach vacuum hose and tools
1. Position the Twist 'n Snap hose assembly on
the vacuum and line up the tabs on the base
of the hose with the corresponding notches.
Turn the Twist 'n Snap hose to the right to
lock into place.
2. Slide the end of the hose grip onto the hose
grip base. Place the hose into the hose clip.
notE: the powerfoot will not operate
effectively unless the hose is firmly
attached to the base.
3. Snap the telescoping extension wand,
crevice tool, and combination tool into the
storage clips as shown.
4. On board TurboBrush ™ (select models only).
The TurboBrush bracket slides onto the
hanger on the front of the handle. Attach the
bracket by aligning the slots with the
rectangular part on the hanger as shown
and pulling down until it is locked into place.
notE: If you do not wish to store the
turbobrush on your lift-off vacuum, the
bracket may be hung on a wall for storage and
hanger may be removed from the vacuum.
Place the TurboBrush in the bracket by
aligning the small holes near the brush roll
with the tabs at the bottom of the bracket
and snap the TurboBrush into place.
Power switch/brush switch
the power switch is located just below the
handle on the front of the detachable cylinder.
push the rocker switch “on” (I) to vacuum, and
“off” (o) when cleaning is complete.
A
ssembly
6
w w w . b i s s e l l . c o m
caUtIon:
before using your vacuum,
make sure that the dirt
container and upper tank are
in locked position and that all
filters (upper tank, pre-motor
and post-motor) are in place.
Do not operate your vacuum
without these filters.
O
peration