Bay Technical Associates 529H - Manual (Page 32)

Status.......................................1
Set Serial Port Configuration................2
Set Message Terminate Character..............3
Set Data Block Length........................4
Set Control Character........................5
Set Mode of Operation........................6
Exit.........................................X
Enter Request:
NOTE: "n" shown on the previous page indicates single-digit port
numbers on the 525H and 528H. The menus of the 5218H will
display nn indicating two-digit port numbers.
 
  
 


By responding to the Enter Request: message at the end of the main
configuration menu (see
Section 6.1 ) with " 2 " (Set Serial Port
Configuration), you may change the configuration of each port (i.e.
baud rate, word size, stop bits, parity and XON/XOFF handshaking).
Note that each port is configured individually. The multiport will
respond with:
Enter Port Number (0=Exit),Return:
You should then enter the number of the port that you wish to
reconfigure, followed by
Carriage Return . Note that if 0 (zero) is
entered, you will exit back to the main configuration menu.
For example, if you enter " 3 " and Carriage Return for Port 3, the
multiport will respond with the current status of Port 3 and a menu of
the available options:
•••••••••••••••••••••••••••••••••••••••••
• Port • Baud • Word • Stop •Parity•Xon/•
• • Rate • Size • Bits • •Xoff•
•••••••••••••••••••••••••••••••••••••••••
• 3 • 9600 • 8 • 1 • None • Off•
•••••••••••••••••••••••••••••••••••••••••
Exit/Save..........1 Set stop bits....4
Set baud rate......2 Set parity.......5
Set word size......3 Set Xon/Xoff.....6
Enter request: