Bay Technical Associates 529H - Manual (Page 35)

30
 

 
By responding to the Enter Request: message at the end of the main
configuration menu (see
Section 6.1 ) with " 4 " (Set Data Block
Length), you may change the data block length used in Mode 6.
The multiport will respond with:
Current Block Length is...................032
Enter Block Length (1 to 250)............:
NOTE: Carriage Return is required after the new length.
Enter the block length that you desire, followed by Carriage Return .
For example, if you enter " 100 " and Carriage Return , the multiport will
respond with:
Current Block Length is..................100
Save Changes Permanently? (Y/N):
If you answer " Y " (yes), the new block length will be saved in
non-volatile memory, and the multiport will subsequently power-up at
that new length. If you answer "
N " (no), the new data block length will
be stored in RAM and will be lost upon next power-up. The multiport
will now return to the main configuration menu (see
Section 6.1 ).