Boss Audio Systems GT-100 - Manual (Page 18)

18
Quick Guide
7
Advanced: Phrase Loop
Press twice
By operating the [PHRASE LOOP] pedal, you can carry out recording and playback in real
time to create layered performances.
Record
Stop Clear/Exit
Press the pedal once again,
and record your guitar
performance.
To stop, press the pedal twice in
succession during overdubbing or
loop playback.
* Press the pedal twice within one second.
To clear the phrase and exit Phrase
Loop, hold down the pedal for at
least two seconds while stopped.
* The recorded content will be erased when you exit
Phrase Loop.
* The recorded content will not be saved.
Loop playback
Play back the loop.
Pressing the pedal will switch to
overdubbing.
Overdub
Record additional layers
while playing back the
loop.
Press the pedal to switch
to playback.
Each time you press the pedal, the
right display will show the phrase
loop status for a predetermined
amount of time.
Hold down two seconds or longer
Enter Phrase Loop mode
Hold down the pedal for two seconds or
longer; the Phrase Loop function will turn
on, and will be in the standby condition.
About Phrase Loop
The recording time is 38 seconds in monaural.
To make settings for Phrase Loop, see “Setting Phrase Loop” (p. 32).
About the pedal’s indicator
The pedal’s indicator will blink or light in a different
pattern according to the Phrase Loop status.
Status Indicator illumination pattern
Standby
...
Recording/Overdub ...
Playback
(stays lit)
Indicator
: lit : unlit