Boss Audio Systems GT-100 - Manual (Page 44)

Making Global Settings (System Settings)
44
Parameter Value Explanation
OUTPUT LEVEL
Setting the OUTPUT LEVEL
Adjusts the level of the output from the GT-100 to the computer.
0–200 % Adjusts the level of the output to the computer.
DIR . MONITOR
Setting the Direct Monitor
Switches the output of the GT-100 sound to the OUTPUT and PHONES jacks.
* This setting cannot be saved. It is set to ON when the power is turned on.
* If you are using the special driver, you can control DIR. MONITOR On/Off from ASIO 2.0-compatible application.
OFF
Set this to Off if transmitting audio data internally through a computer (Thru).
No sound is heard at this time unless the setting for the computer is Thru.
ON
The GT-100 sound is output. Set this to ON when using the GT-100 as a standalone device, without connecting to a computer
(only USB input sound will be output if this is set to Off).
DIR . MONITOR CMD
Controlling the Direct Monitor Setting from a Computer
This setting determines whether or not the command (the Direct Monitor command) controlling the Direct Monitor setting is enabled.
DISABLE The Direct Monitor command is disabled, maintaining the Direct Monitor mode set by the GT-100.
ENABLE The Direct Monitor command is enabled, allowing the Direct Monitor mode to be switched from an external device.
MIDI-Related Settings
Here you can make settings for using the GT-100 connected with an external MIDI device or with a second GT-100 unit.
Reference
For details on MIDI, refer to “Using the GT-100 with External MIDI Devices Connected” (p. 47).
MIDI SETTING
Parameter Value Explanation
RX CHANNEL
Setting the MIDI Receive Channel
This sets the MIDI channel used for receiving MIDI messages.
Ch. 1– Ch. 16 Specifies the receive channel.
OMNI MODE
Setting the MIDI Omni Mode
This makes the settings for the channels used for MIDI information.
OFF Information is received on the channel specified by the Rx Channel setting.
ON Messages are received on all channels, regardless of the MIDI channel settings.
TX CHANNEL
Setting the MIDI Transmit Channel
This sets the MIDI channel used for transmitting MIDI messages.
Ch. 1– Ch. 16. Specifies the transmit channel.
RX Transmits on the same channel as the RX CHANNEL.
DEVICE ID
Setting the MIDI Device ID
This sets the MIDI Device ID used for transmitting and receiving Exclusive messages.
1–32 Sets the MIDI Device ID.
SYNC CLOCK
Setting the MIDI Sync Clock
This setting determines the basis used for synchronizing the timing for effect modulation rates and other time-based parameters.
* When you have an external MIDI device connected, the Master BPM is then synchronized to the external MIDI device’s tempo, thus disabling the
Master BPM setting. To enable setting of the Master BPM, set to “INTERNAL.”
* When synchronizing performances to the MIDI Clock signal from an external MIDI device, timing problems in the performance may occur due to
errors in the MIDI Clock.
AUTO
Operations are synchronized to the MIDI Clock received via MIDI. However, operations are automati-
cally synchronized to the GT-100’s internal Clock if the GT-100 is unable to receive the external Clock.
INTERNAL Operations are synchronized to the GT-100’s internal Clock.