Philips Viva Cafetière - Manual (Page 6)

6
5 Using the appliance
5.1 Brewing coffee
1
Make sure the plug is in the wall socket.
2
Fill the water tank with fresh, cold
water (Fig. 6).
• The graduations on the left are for large
cups (120ml).
• The graduations on the right are for small
cups (80ml).
3
Open the filter holder (Fig. 7).
4 Take a paper filter (type 1x4 or no. 4) and
fold the sealed edges to prevent tearing and
folding (Fig. 8).
5 Put the filter in the filter holder (Fig. 9).
D Note:
Some versions come with a permanent filter. In
this case you do not need to use paper filters.
6 Put ground coffee (filter-fine grind) in the
filter (Fig. 10).
• For large cups: use one heaped measuring
spoon of ground coffee for each cup.
• For small cups: use one level measuring
spoon of ground coffee for each cup.
7
Close the filter holder. (Fig. 11)
8
Place the jug on the hotplate (Fig. 12).
9
Switch on the appliance.
• HD7564/HD7563/HD7562: Press the on/
off rocker switch. The power-on light goes
on (Fig. 13).
• HD7566/HD7565: Press the on/of button.
The power-on light ring round the button
goes on (Fig. 14).
• HD7567: Press the on/off button. The
power-on light goes on.
10 When all the water has passed through
the filter, you can remove the jug from the
appliance (Fig. 15).
B Warning:
If you remove the jug for more than 30
seconds before all the water has passed
through the filter, the filter may overflow.
3 General
description (Fig. 1)
A Filter holder
B Detachable front cover
C Water tank lid
D Water tank
E Coffeemaker
F Mains cord
G On/off rocker switch with power-on
light (HD7564/HD7563/HD7562)
H Buffer ring (HD7567/HD7562)
I Jug
J Jug lid with mixing pipe
K On/off button with power-on light ring
(HD7566/HD7565)
L Display with timer and on/off button with
power-on light (HD7567)
4 Preparing for use
1
Put the appliance on a flat and stable surface.
2
Put the plug in an earthed wall socket.
3
To store excess cord, push it into the opening
at the back of the coffeemaker (Fig. 2).
4.1 Setting the clock (HD7567
only)
1
After you have put the plug in the wall socket,
the word ‘SET’ appears on the display (Fig. 3).
2
Press the ‘h’ button one or more times to set
the hour (Fig. 4).
• The display shows the set hour (e.g. 7:00).
3 Press the ‘M’ button one or more times to set
the minutes (Fig. 5).
• The display shows the set minutes
(e.g. 7:20).
4222_200_0125_2_DFU-Redesign_A5_v2.indd 6 6/22/12 1:29 PM