7 ordering accessories, 8 environment, 9 guarantee and support – Philips Grind & Brew Cafetière User Manual

Page 10

Advertising
background image

10

7 Ordering accessories

To buy accessories or spare parts, visit

www.shop.philips.com/service or go to your

Philips dealer. You can also contact the Philips

Consumer Care Centre in your country (see the

worldwide guarantee leaflet for contact details).

8 Environment

• Do not throw away the appliance with the

normal household waste at the end of its life,

but hand it in at an official collection point for

recycling. By doing this, you help to preserve

the environment (Fig. 24).

9 Guarantee and

support

if you need information or support, please visit

www.philips.com/supportor read the separate

worldwide guarantee leaflet.

D

Note:

if you are not aware of the water hardness in your

area and are not in a position to contact your

local water board, we advise you to descale the

appliance every time the ‘CALC’ message appears

on the display.

D

Note:

To remove the ‘CALC’ message from the display,

press the 2-10 CUPS button and the STRENGTH

button simultaneously.

1

Open the water reservoir lid.

2

Fill the water reservoir with 7 cups of white

vinegar (4% acetic acid) and 3 cups of

water (Fig. 23).

3

Place a paper filter (no. 4) in the filter basket

and close the filter basket holder.

4

Place the empty jug on the hotplate (Fig. 4).

5

Put the mains plug in the wall socket.

6

Press the start/standby button.

7

Press the pre-ground coffee button to switch

off the grinder. Then press the start/standby

button to start the brewing process.

8

Wait until half of the vinegar-water solution

has flowed into the jug. Then press the start/

standby button to stop the brewing process

and let the solution soak for at least 15

minutes.

9

Press the start/standby button to switch the

coffeemaker back on and wait until the rest

of the solution has flowed into the jug. Then

press the start/standby button to put the

appliance in standby mode.

10

Empty the jug and throw away the paper filter.

11

Fill the water reservoir with cold water

and press the start/standby button to

start another brewing process. Let the

coffeemaker complete the entire brewing

process and empty the jug.

12

Repeat step 12 until the water no longer

tastes or smells like vinegar.

13

Clean the filter basket and the jug with hot

water and some washing-up liquid.

Advertising
This manual is related to the following products: