Philips Grind & Brew Cafetière - Manual (Page 7)

7
5.2 Using coffee beans
B Warning:
Do not put espresso coffee beans in the coffee
bean container. Only use regular coffee beans.
B Warning:
Always keep the water reservoir lid closed when
you fill the coffee bean container with coffee
beans. Otherwise coffee beans can fall into the
water reservoir and block up the water inlet.
1
Press the OPEN button on the right-hand
side of the appliance to open the filter basket
holder. (Fig. 9)
2
Place a paper filter (no. 4) in the filter basket
to collect the ground coffee. (Fig. 10)
3
Remove the coffee bean container lid (1) and
fill the container with coffee beans (2). Make
sure there are enough coffee beans in the
container for the amount of coffee you want
to brew (Fig. 11).
D Note:
Always make sure the bean container is at
least half full.
B Warning:
The maximum capacity of the coffee bean
container is 250g. To prevent the grinder
from jamming, do not exceed this amount.
B Warning:
To prevent the grinder from jamming, do not
use unroasted or caramelised beans.
4
Turn the grind selection knob to select the
desired type of grind (from fine to coarse).
There are nine grind settings (Fig. 12).
E Tip:
We advise you to experiment with the
different grind settings to find out which
setting you prefer.
5
To select the number of cups, press the
2-10 cups button as many times as the
desired number of cups (Fig. 13).
D Note:
When you switch off the grinder, the number
of cups and the strength setting are not
shown on the display.
8
Press the start/standby button to start the
brewing process (Fig. 7).
9
Let the appliance operate until all the water
has flowed into the jug.
• The coffeemaker produces 5 beeps when
the brewing process is finished.
10
Press the start/standby button to stop the
brewing/ keep-warm process. (Fig. 5)
11
Empty the jug.
5 Using the appliance
5.1 Filling the water reservoir
1
Open the water reservoir lid and fill the water
reservoir with the required amount of cold
water (Fig. 3).
There are indications for 2 to 10 cups (275ml
to 1375ml) on the water level window and
on the jug. You can use these indications to
determine how much water to put in the
water reservoir. Keep in mind that the amount
of brewed coffee will be slightly less, since
ground coffee absorbs water.
E Tip:
Use the jug to fill the water reservoir with the
required amount of water.
D Note: (Fig. 8)
Do not fill the water reservoir beyond the
10-cup indication, otherwise water spills from
the opening at the back.
ENGL
iSH