Liebherr MKv 3910 - Manual (Page 10)

22
Defrosting
The appliance defrosts automatically. The water that forms on the
rear wall drains into a reservoir at the back of the appliance and
evaporates automatically through the compressor heat.
Safety lock
The lock in the appliance door is equipped with a safety mecha-
nism.
Locking the appliance
• Insert the key as shown by ar-
row 1.
• Turn the key 90°.
To unlock the appliance, the same
procedure must be repeated in the
same order.
Setting the display indication for the defrost
phase
The following indications can be set for the defrost phase.
• Symbol + alternating display of and the current tem-
perature in the interior of the appliance.
• Symbol + temperature before the start of the defrost phase
(factory setting).
• Symbol + .
Change the display during the defrost phase
Press for 5 seconds. Display =
Display =
Use buttons and to select the desired setting.
= alternating display of and the current temperature in
the interior of the appliance.
= temperature before the start of the defrost phase.
= display of only.
Display =
Press for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Interior light MKv 3913
The interior light is fitted on the inside at the top.
The interior light can be switched
on and off using the
button.
The light intensity of the LED
light corresponds to laser
class 1/1M.
Important
The light cover may only be
removed by customer service
staff.
If the cover is removed, do not look directly at the light
through optical lenses from close distance.
This can damage your eyes.