New Buck Corporation 81 User Manual
Page 18
three (3) sheet metal screws or rivets. Next, install an optional New Buck Corporation
chimney connector to flue exit of heater. (See Figure 6).
4. Install Single Wall Connector and chimney system per manufacturer’s written operating in-
structions. See manufacturer’s list of tested pipes in this manual.
Figure 6
Figure 7
B. Wall Exit Into Metal Tee-Box
1. Mark the plumb line on wall directly behind center of heater. (See Figure 7).
NOTE: When using #24 ga. minimum blue or black steel pipe maintain 18" between pipe and
ceiling.
2. Place vertical portion of heater pipe and elbow in position and project a point onto plumb
line level with center of the elbow.
3. Measure up so there will be at least 1/4" rise per foot of horizontal connector pipe,
(3) sheet
metal
screws
or rivets.
Optional
New Buck
Corporation
chimney
connector
Page 16