Philips SENSEO® Twist & Milk Kaffeepadmaschine - Manual (Page 11)

11
2 To enter the programming mode, first select
the personal coffee memory symbol (star
symbol) with the selection button (1). Keep
the selection button pressed for 2 seconds
until the star symbol starts flashing (2) and
you hear a beep. Then release the selection
button.
3 Press the 1-cup button to make the coffee
flow into the cup (1). When the cup contains
the amount of coffee you prefer, press the
1-cup button again (2). Your preferred amount
of coffee has been set.
From now on, your SENSEO ® machine brews one
or two cups with this amount of coffee when you
select the personal coffee memory symbol with
the selection button.
D Note:
If you want to change the set amount of coffee,
simply perform steps 1-3 again.
12 When the coffee is ready, remove the used
coffee pod or pods. Simply lift the pod holder
out of the machine and empty it.
C Caution:
There may still be some hot water/coffee on
the coffee pod or pods.
13
After use, press the on/off button 3 to switch
off the machine.
D Note:
If you do not use the machine, it switches off
automatically after 15 minutes to save energy.
5.1 Personal coffee memory
(HD7872 only)
You can program the machine to brew the
amount of coffee you prefer (up to 145ml). Simply
experiment and find out what you like best. We
advise you to brew at least 60ml for optimal taste
and temperature.
While programming, you can only use the
1-cup button. When you have completed the
programming process, you will be able to brew
one or two cups with the programmed amount
of coffee.
D Note:
It is not possible to program your personal coffee
memory while the machine is heating up. Wait
until the on/off button lights up continuously.
1 Place 1 coffee pod in the 1-cup pod holder
and place 1 cup under the spout openings.
ENGLISH
4222_200_0566_3_DFU-Redesign_A5_v2.indd 11 6/18/12 4:54 PM