Configure server properties – B&B Electronics Vlinx Serial Servers ESP902E User Manual
Page 19
Using ESP Manager
Manual Documentation Number: ESP901-902-3704
Chapter 4
27
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Pk – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Step 5:
Enter the
IP Address
assigned to the desired
Serial Server
or
click
Search all reachable servers,
then
OK.
IP Address
is
used to find
Serial Server
units that are not on the same
subnet. (Routers on the network will block the standard
broadcast used to find servers if
Search all reachable servers
is selected.) The user must set an IP address that conforms to
the LAN addressing scheme.
The Searching window is shown until all active
Serial
Servers
on the LAN are listed in the
Serial Server List
window.
Figure 23.
The Search VLINX ESP Dialogue Box
Configure Server Properties
The
Server Properties
window displays the current
configuration properties for the currently selected server.
Step 6:
To open the
Server Properties
window, highlight the
Serial
Server
in the
Serial Server List
window, double-click to
open.
The
Server Properties
window is used to configure and store
the Server configuration settings. Details for setting Properties
are described in the next chapter.
Using ESP Manager
28
Chapter 4
Manual Documentation Number: ESP901-902-3704
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Pk – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Figure 24. The Server Properties Window
N
N
o
o
t
t
e
e
:
:
ESP Manager Navigation:
-
Use the mouse to select the property and parameters or
-
Tab to move to the next property
-
Tab+Shift to move back to previous property
-
Arrows to move between properties or change values or
contents of the current property
-
Enter to select update or cancel
Step 7:
After configuring as needed, click
Update
to store the
configuration in the server. The following window will
appear:
Figure 25. The Restart Dialogue Box
Step 8:
Click
Yes
to restart. The following dialogue box will appear: