Black Box COMPACT T1 MT850A User Manual
Compact t1, User manual
Advertising
Compact T1
USER MANUAL
CUSTOMER
SUPPORT
INFORMATION
Order toll-free in the U.S.: Call 877-877-BBOX (outside the U.S. call 724-746-5500)
FREE technical support, 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mail order: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
Web site: www.blackbox.com • E-mail: [email protected]
M
AY
2003
P
RODUCT
P/N MT850A
770-0110-AA
Advertising
Table of contents
Document Outline
- Compact T1 User Manual
- Preface
- Table of Contents
- 1 - Base Platform
- 2 - Physical Installation
- 3 - Electrical Installation and Cabling
- 4 - Configuration
- Setting up a CLI Connection
- System Information
- Basic System Setup
- Initial Setup
- Set Up Security
- Set Up a DS1/T1
- Set Up a DS0/Channel
- Set Up an Analog Port
- Set Up the Router Card
- Establish a Static Channel Connection
- Set Up a ISDN BRI Service
- Set Up the OCU-DP Card
- Set Up a V.35 Port
- Change the IP Address of the DS0 Management Channel
- Upgrade the Controller Software
- Upgrade the Router (IP or CMG) Software
- Quick Configuration Reload
- Setup of DS0 Management Channel
- Equipment Required
- Application Overview
- Operation
- Provision DS0s for data and cross-connect to the outgoing T1
- Configure the Router
- Setup the Profile for Site A
- Setup the Profile for Site B
- Setup the Profile for Site C
- Remote Site A Configuration
- Remote Site B Configuration
- Remote Site C Configuration
- Test
- 5 - CLI Commands
- Command Line Interface Help
- CLI Commands
- aco (Alarm Cut Off)
- add
- add (router) dns proxy
- add (router) remote
- add (router) snmp community
- add (router) snmp trap
- add (router) static dns host
- add (router) uploaduser
- add (router-lan) filter
- add (router-lan) secondary ip address
- add (router-lan) static
- add (router-wan) firewall
- add (router-wan) gre network
- add (router-wan) nat bypass
- add (router-wan) static
- add user
- alarms
- clear
- connect
- delete
- delete (router) dns proxy
- delete (router) remote
- delete (router) snmp community
- delete (router) snmp trap
- delete (router) static dns host
- delete (router) uploaduser
- delete (router-lan) filter
- delete (router-lan) secondary ip address
- delete (router-lan) static
- delete (router-wan) firewall
- delete (router-wan) gre network
- delete (router-wan) nat bypass
- delete (router-wan) static
- delete (router-wan) static ipx network
- delete user
- disconnect
- exit
- install
- load
- log
- ping
- rename (router)
- reset
- restore
- rtrping
- set
- set alarms
- set autoexit
- set (bri)
- set (bri) autoactivate
- set (bri) mode
- set (bri) pmsync
- set clock
- set date
- set (ds0)
- set (ds1)
- set ethernet ip address
- set (fxo)
- set (fxs5G)
- set id
- set ip gateway
- set ipds0
- set local
- set login auth
- set login support
- set ntp
- set (ocudp) baud
- set (ocudp) loopback
- set (ocudp) loopdetect
- set (ocudp) mvec
- set (ocudp) secondary
- set (ocudp) selftest
- set (ocudp) up/down
- set radius
- set (router) autologout
- set (router) cdr
- set (router) compander
- set (router) default
- set (router) dhcp
- set (router) dns
- set (router) enhanced security
- set (router) hookflash
- set (router) lmi
- set (router) lmi poll
- set (router) log
- set (router) login auth
- set (router) login prompt
- set (router) mgcp
- set (router) ntp
- set (router) password
- set (router) ppp auth
- set (router) ppp security
- set (router) priority tos
- set (router) proxy
- set (router) reboot
- set (router) rip
- set (router) snmp
- set (router) stp
- set (router) syslog
- set (router) voip
- set (router-lan) collision
- set (router-lan) filter forward
- set (router-lan) framing
- set (router-lan) gateway
- set (router-lan) ip address
- set (router-lan) ipx network
- set (router-lan) phy
- set (router-lan) rip
- set (router-lan) stp
- set (router-lan) up/down
- set (router-trunk) encapsulation
- set (router-trunk) multilink group
- set (router-trunk) up/down
- set (router-trunk) voice bandwidth limit
- set (router-voice) algorithm preference
- set (router-voice) cpd
- set (router-voice) default
- set (router-voice) down
- set (router-voice) dtmfrelay
- set (router-voice) echo cancellation
- set (router-voice) echo tail
- set (router-voice) endpoint prefix
- set (router-voice) endpoint suffix
- set (router-voice) log start
- set (router-voice) log stop
- set (router-voice) rxgain
- set (router-voice) silence
- set (router-voice) slash
- set (router-voice) tos
- set (router-voice) txgain
- set (router-voice) up
- set (router-wan) dlci
- set (router-wan) gre
- set (router-wan) ip
- set (router-wan) ip address
- set (router-wan) ipx
- set (router-wan) nat
- set (router-wan) other
- set (router-wan) ppp
- set (router-wan) rip
- set (router-wan) stp
- set (router-wan) trunk
- set (router-wan) up/down
- set screen
- set snmp
- set syslog
- set time
- set user
- set (v35)
- set (v54)
- set verification
- show
- show autoexit
- show (bri)
- show clock
- show connect
- show date
- show (ds0)
- show (ds1)
- show ethernet
- show (fxo)
- show (fxs5G)
- show impedance
- show id
- show ip
- show ipds0
- show local
- show login
- show ntp
- show (ocudp)
- show radius
- show (router)
- show (router) dhcp
- show (router) dns
- show (router) dns proxy
- show (router) lmi
- show (router) log
- show (router) mgcp
- show (router) mgcp algorithmname
- show (router) ntp
- show (router) ppp
- show (router) rip
- show (router) snmp
- show (router) stp
- show (router) syslog
- show (router) uploaduser
- show (router) voip
- show (router-lan)
- show (router-lan) collision
- show (router-lan) filter
- show (router-lan) static
- show (router-lan) stp
- show (router-voice)
- show (router-wan)
- show (router-wan) firewall
- show (router-wan) nat bypass
- show (router-wan) ppp
- show (router-wan) static ip address
- show (router-wan) static ip network
- show (router-wan) static ipx network
- show (router-wan) static mac address
- show (router-wan) static nat address
- show (router-wan) stp
- show (router-wan) trunk
- show screen
- show snmp
- show syslog
- show time
- show users
- show (v35)
- show (v54)
- show (wan)
- status
- status (bri)
- status clock
- status (ds0)
- status (ds1)
- status equipment
- status (fxo)
- status (fxs5G)
- status ipds0
- status (ocudp)
- status (ocudp) performance
- status (ocudp) performance history
- status (router)
- status (router) alarms
- status (router) channels
- status (router) dns
- status (router) events
- status (router) ip address table
- status (router) ip network table
- status (router) ipx network table
- status (router) ipx server table
- status (router) log
- status (router) mac address table
- status (router) mgcp
- status (router) performance
- status (router) stp
- status (router-lan)
- status (router-trunk)
- status (router-voice)
- status sessions
- status (v35)
- status (v54)
- store
- telnet
- 6 - T1 Controller Card
- 7 - FXO Voice Card
- 8 - FXS Voice Card
- 9 - ISDN BRI Card
- 10 - OCU-DP Card
- 11 - Power Supply
- 12 - Quad T1 Card
- 13 - Router (IP) Card
- 14 - Router (CMG) Card
- Overview
- Features
- Technical Specifications
- Controller Software Required
- Management
- Voice and Packet Interfaces
- Voice Processing and Mediation
- Connection Types (Media Flows)
- Routing and Policy Management
- Router Performance
- Advanced Capabilities
- TDM-Side Signaling
- Softswitch Call Control and Signaling
- Services Enabled (under Softswitch Control)
- Softswitch/Call Agent Interoperability
- Network Standards
- Power
- Regulatory Approvals
- Physical
- Card Configuration
- Connector Pinout
- Softswitch Interoperability Settings
- LEDs
- 15 - V.35/V.54 Cards
- 16 - Maintenance
- A - SNMP Interface
- B - Diagnostices & Troubleshooting
- Glossary
- Index