Black Box COMPACT T1 MT850A - Manual (Page 259)

Compact T1 - Release 6.1 5-175
CLI Commands
set
set (router-voice) endpoint prefix
Use the set (router-voice) endpoint prefix command to set the common part of the MGCP
endpoint name for one or more voice channels. The default prefix is "aaln". Note the endpoint
prefix is combined with the endpoint suffix to form a complete MGCP endpoint name in the
form "prefix/suffix" (the slash is added) for each voice channel. These names are used by a call
agent to address the channel. The intent of the prefix part of the name is to indicate the type of
voice channel. For example, "aaln" refers to analog (FXS) lines, while "ds0" could refer to the
channels of a T1 line. However, unless a call agent demands it, there is no restriction on the
prefix name. This command applies to the CMG Router card only.
Syntax: set {cmg_voice-addr} endpoint prefix {"prefix"}
Example: set 2:1:1:all endpoint prefix "ds0"
The example will set endpoint prefix to "ds0" on all the voice channels on the
CMG card in slot 2.
{cmg_voice-addr}
In the form {slot:voip:port}
{"prefix"}
An identifier with a maximum of 16 characters, enclosed in quotes.
slot The slot number (1-6) that contains the CMG card.
voip To designate VoIP 1:1 is used.
channel Channel number for the router is 1-48, range or all