Brocade Communications Systems Brocade EZSwitchSetup 5100 - Manual (Page 25)

EZSwitchSetup Administrator’s Guide 13
53-1002157-01
Installing and running the EZSwitchSetup wizard
2
Confirming IP addresses
The Confirm IP Address screen ( Figure 10 ) is displayed after you have assigned IP addresses, using
either a serial connection or an Ethernet connection.
1. Check the displayed addresses carefully to be sure they are correct.
FIGURE 10 EZSwitchSetup Confirm IP Address
2. Click Next to confirm the addresses.
The Continue Configuration? screen is displayed ( Figure 11 ).
3. Select one of the following continuation options:
• Continue setting up your target switch with EZManager
Select this option if you intend to use EZSwitchSetup Manager as your primary
management program for this switch.
• Discover another switch on the same subnet for IP assignment only
Select this option to discover another switch and set the IP address.
If you select this option, EZSwitchSetup Manager will not be the default management tool
for this current target switch. To set up EZSwitchSetup Manager as the management tool
for this switch, you must discover it again with EZSwitchSetup and select the first
continuation option.