Rockwell Automation 1734-AENT POINT I/O EtherNet/IP Adapter Module - Manual (Page 57)

Publication 1734-UM011D-EN-P - May 2011
Configure the Adapter for Direct Connection in RSLogix 5000 Software 41
5. From the Download dialog, choose Download to see the RSLogix 5000
software dialog.
6. Notice that the 1756-ENBT Bridge is now online.
If yellow triangles are present, see the following section.
Verify the Module Chassis
Size
You have now built the I/O tree in RSLogix 5000 software, and the
RSLogix 5000 software used the chassis size from the 1734-AENT General
tab.
Now you need to download this new chassis size value into the 1734-AENT
adapter hardware. This procedure synchronizes the chassis size value from the
RSLogix 5000 software into the 1734-AENT adapter hardware.
1. Verify that RSLogix 5000 is online.
2. Right-click the 1734-AENT adapter under I/O Configuration in the
Project dialog.
3. Select Properties.
4. Click the Connection tab.