Brother BE-1201B-AC-PC - Manual (Page 152)

6-32 BE-0901E-AC-PC• BE-1201B-AC-PC
Chapter 6 Embroidering
Boring
! The following items can be set.
Boring Sets whether or not boring is performed by attaching a boring knife to the needle
bar.
Shift data Shifts the hoop by 12 mm while the needle bar with a boring knife attached is
selected.
Shift needles Sets the range of needle bar to be shifted. Normally, a boring knife is attached to
No. 1 needle bar. Set 1 - 1.
! TheBoring setting can be performed only for embroidering data that has been created for boring.
The machine cannot check whether embroidering data is for boring or not. When performing
embroidering, be sure to check the data.
! Before performing embroidering, attach the following optional parts to the machine.
• Boring knife
• Boring needle plate, Finger guard
!
If editing such as reduction/enlargement and rotation is applied to embroidering data that has been
created for boring, embroidering may not be performed correctly.
1. Select [Boring] from Settings menu.
W1733
2. Set the boring, shift, and range of needle bar.
W1734
3. Click [OK].