Hale ESP Priming System User Manual
Page 32
❑ Installation
32
ESP Primer System Instruction Guide
p/n: 029-0810-01-0
WARNING - continued !
ALWAYS FOLLOW THE MANUFACTURER’S RECOMMENDED INSTRUCTIONS
ON THE LABEL AFIXED TO THE CONTAINER.
Notes:
❑
DO NOT use water only in the lubricant tank in FREEZING climates.
❑
The propylene glycol must be the type that includes corrosion inhibi-
tors. An example would be propylene glycol antifreeze recommended
for the RV or Marine type cooling systems.
8.
Make sure the vent hole in the lubricant tank fitting and discharge tank
breather vent are clean (not clogged or blocked).
9.
Fill the tank with an approved propylene glycol coolant - see heading
“Lubricated ESP Primer System” on page 14.
DO NOT USE ETHYLENE GLYCOL.
10.
Make sure the drain valve in the discharge collection tank is CLOSED to
prevent accidental discharge to the ground.
11.
Install the Fluid Capacity Placard, required by NFPA, inside the opera-
tor’s cab. The placard must state “
DO NOT USE ETHYLENE GLYCOL” in
the lubricant system and should include the lubricant warings listed in the
section.