Section 5 - attachments, 1 approved attachments, 1 approved attachments -1 – SkyTrak 10054 Operation Manual User Manual
Page 73: D section 5 - attachments
Section 5 - Attachments
5-1
31200352
SECTION 5 - ATTACHMENTS
5.1
APPROVED ATTACHMENTS
To determine if an attachment is approved for use on the specific telehandler you
are using, perform the following prior to installation.
Before S/N 0160037788
• Must be an approved SkyTrak attachment. The model/option number on the
attachment identification plate must be contained within this section.
• The model on the capacity chart must match the model telehandler being used.
• The load center of the fork (if equipped) must match the load center as indicated
on the capacity chart.
• Hydraulically powered attachments must only be used on machines equipped
with auxiliary hydraulics.
• Hydraulically powered attachments that require auxiliary electrics must only be
used on machines equipped with auxiliary hydraulics and electrics.
S/N 0160037788 & After
• The attachment type, weight, dimensions and load center must be equal to or
less than the data shown on a capacity chart located in the operator cab.
• The model on the capacity chart must match the model telehandler being used.
• Hydraulically powered attachments must only be used on machines equipped
with auxiliary hydraulics.
• Hydraulically powered attachments that require auxiliary electrics must only be
used on machines equipped with auxiliary hydraulics and electrics.
If any of the above conditions are not met, do not use the attachment. The
telehandler may not be equipped with the proper capacity chart or the attachment
may not be approved for the model telehandler being used. Contact JLG or a local
distributor for further information.