AEM 30-3520 Infinity Plug & Play Harnesses - Nissan/Infiniti 2003-2006 350Z/G35 User Manual
Page 33
2003–2006 Nissan 350Z/Infiniti G35
33
© 2014 AEM Performance Electronics
Infinity
Pin
Hardware Reference
2003–2006 350Z/
G35
Specification
Dest. Pin
350Z/
G35
Hardware Specification
Notes
C2-15
Harness_Analog_In_Temp_4
Cruise Control
Steering Buttons
99
12 bit A/D, 2.49K pullup
to 5V
Use 1D table "CC_State_Analog" to
conf igure.
C2-16
Harness_Analog_In_Temp_5
Airbox
Temperature
12 bit A/D, 2.49K pullup
to 5V
See AirboxTemp [C] table f or
calibration data and AirboxTemp [C]
f or channel data.
C2-17
Harness_Analog_In_Temp_6
Fuel
Temperature
107
12 bit A/D, 2.49K pullup
to 5V
See FuelTemp [C] table f or calibration
data and FuelTemp [C] f or channel
data.
C2-18
Harness_Analog_In_13
Oil Pressure
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. See Setup
Wizard Oil Pressure page f or setup
options. See OilPressure [psig] f or
channel data.
C2-19
Harness_Analog_In_14
Traction Control
Mode /
Sensitiv ity
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. See the
TC_SlipTrgtTrim [MPH] 1-axis table. A
multi-position rotary switch such as
AEM P/N 30-2056 is recommended.
C2-20
Harness_Analog_In_15
Exhaust Back
Pressure
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the
ECU. See Setup Wizard Exhaust
Pressure page f or setup options. See
EBPress [kPa] f or channel data.
C2-21
Harness_Analog_In_16
Throttle Position
Sensor 2
69
12 bit A/D, 100K pullup to
5V
0–5V analog signal. Use +5V Out pins
as power supply and Sensor Ground
pins as the low ref erence. Do not
connect signals ref erenced to +12V as
this can permanently damage the
ECU. See the Driv e by Wire Wizard
f or calibration.
C2-22
+5V_Out_2
+5V Out
Ref rigerant
Press
49
Regulated, f used +5V
supply sensor power
Analog sensor power
C2-23
+5V_Out_2
+5V Out Pwr
Steering Press
68
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-24
+5V_Out_2
+5V Out APP1/
APP2
90, 91
Regulated, f used +5V
supply f or sensor power
Analog sensor power
C2-25
Harness_VR+_In_5
Driv en Right
Wheel Speed
Sensor +
Dif f erential Variable
Reluctance Zero Cross
Detection
See Driv en Wheel Speed Calibration in
the Setup Wizard Vehicle Speed page.
C2-26
Harness_VR-_In_5
Driv en Right
Wheel Speed
Sensor -
C2-27
Harness_VR-_In_4
Non Driv en
Right Wheel
Speed Sensor -
Dif f erential Variable
Reluctance Zero Cross
Detection
See Non Driv en Wheel Speed
Calibration in the Setup Wizard Vehicle
Speed page.