Apple Newton Connection Utilities (for Macintosh) - Manual (Page 40)

Ending a keyboard session
When you’ve finished entering information from the keyboard, you can end a
keyboard session by any of the following methods:
m On your computer, click the Stop button in the Keyboard status window.
m On your Newton device, tap the Dock button. When a message appears
asking whether you want to end your keyboard session, tap Yes.
m Tap the star ( ✩ ) at the top of your Newton screen and tap Dock. When a
message appears asking whether you want to end your keyboard session,
tap Yes.
Copying text from the Clipboard
During a keyboard session, you can copy text from your computer’s Clipboard
to your Newton device.
To copy text from the Clipboard, follow these steps:
1 Open the Newton Connection Utilities and start a keyboard session.
For instructions, see “Starting a Keyboard Session” earlier in this chapter.
2 On your computer, copy text to the Clipboard.
3 Set the insertion point on your Newton device.
4 Click the “Paste from Clipboard” button in the Keyboard status window.
Text from the Clipboard appears on your Newton device.
Note: You can also paste text by typing x-V on your computer’s keyboard.
When you copy text to your Newton device:
m Graphics are not copied.
m The “Paste from Clipboard” button is dimmed if the Clipboard contains
no text.
m It may take a few seconds for large amounts of text to appear on your
Newton device.
40 Chapter 4