Buhler 2895 - Manual (Page 16)

bühler
Allied Front-End Loader
or back grading, either load the bucket and
position must be used to
– Frame: Standard and Heavy Duty A – Frames can be fitted with either
Standard Duty
uty frame is for handling
Heavy Duty 60”
60” frame is for handling
ty frame can also be
F
position the heel on the ground or position
the bucket at 40
q or less below level as
shown. Place the valve in the float position
and back up slowly.
IMPORTANT: Float
reduce down pressure, otherwise cylinder
rod(s) and/or bucket damage could occur.
A
spears or pallet forks.
-
The standard d
medium sized round bales (up to 1000 lbs.)
fitted with a single centered 1240mm long
heat treated spear and two short stabilizers.
For pallet applications with a maximum load
up to 2000 lbs. when fitted with 42.0” fork kit.
-
The Heavy Duty
medium to large sized round bales (up to
2000 lbs.) when fitted with two bottom
1240mm long heat treated spears and two
short stabilizers. For pallet applications with
a maximum payload of 4400 lbs. when fitted
with the 48.0” fork kit.
NOTE: The heavy du
fitted using only the one center spear as per
the standard duty A-frame.
- 14 - P4110