Buhler 2895 - Manual (Page 23)

bühler
Allied Front-End Loader
INSTALLING / REMOVING LOADER ATTACHMENTS
Installing:
1. Position tractor centrally within the
bucket hooks. Dump Quick-tach slightly from
vertical position. Slowly drive the tractor
forward until the Quick-tach contacts the
bucket.
2. Slowly raise the loader to engage the
Quick-tach within both bucket hooks. When
both hooks are resting on the Quick-tach
rollback the bucket. Shut tractor off. Lock
using both Quick-tach pins and secure with
hairpin clips.
CAUTION
Verify attachment installation from tractor seat by
lowering level attachment to ground and retracting the lift cylinders.
Removing:
1. Rollback attachment and lower near
ground position. Shut tractor off.
2. Remove both Quick-tach pins and place in
storage position. Place level attachment on
ground. Slowly dump attachment while
backing tractor away.
- 21 - P4110
Pin in lock
position.
Pin in storage position