Buhler 2895 - Manual (Page 25)

bühler
Allied Front-End Loader
- 23 - P4410
MAINTENANCE
General Inspection:
CAUTION
Lower attachment and loader to ground, place all
controls in neutral, stop engine, set parking brake and remove ignition key before
inspecting, servicing, adjusting or repairing loader.
WARNING
Relieve hydraulic pressure before repairing, adjusting
or disconnecting hydraulics components. Escaping hydraulic oil can penetrate
skin causing serious personal injury. If injured consult a physician immediately.
WARNING
Never work beneath a raised loader unless it is
securely supported. The control lever can be moved or a hydraulic leak could
cause the loader to drop resulting in serious injury or death. Refer to the
Hydraulic Lift Lock Instructions Decal for proper use of the lift lock.
Hydraulic Lift Lock: The lift lock on your loader is to be used whenever
someone is attempting to be under the loader or for tractor servicing. When
using the lock ensure loader is free of any load in the loader attachment or no
attachment.
To engage hydraulic lift lock, raise loader to
desired service height. Rotate lever on
hydraulic lock 90
o
clockwise to lock. Then lock
joystick in neutral position. Do not use if there
are any hydraulic leaks.
Pins and Bushings: Every 6 months or 1000 hours check loader and cylinder
pivots for movement that would be due to bushing or pin wear. Change bushings
when excessive movement is noticed and replace any worn or rough surfaced
pins.