Rear window wiper/washer, Compass, Rear window wiper/washer on – Buick 2011 Enclave User Manual

Page 132: Rear window, Wiper/washer -6, Compass -6

Advertising
background image

Black plate (6,1)

Buick Enclave Owner Manual - 2011

5-6

Instruments and Controls

Windshield Washer

J

(Washer Fluid): Press the

button at the end of the turn
signal/lane change lever, to spray
washer fluid on the windshield.
The wipers clear the windshield and
either stop or return to the preset
speed. The ignition key must be in
ACC/ACCESSORY or ON/RUN for
this to work. See Washer Fluid on
page 10‑23
.

{

WARNING

In freezing weather, do not use
your washer until the windshield
is warmed. Otherwise the washer
fluid can form ice on the
windshield, blocking your vision.

WASHER FLUID LOW ADD
FLUID is displayed on the Driver
Information Center (DIC) when the
washer fluid is low. See Washer
Fluid Messages on page 5‑39
.

Rear Window
Wiper/Washer

The rear wiper and rear wash button
is located on the instrument panel
below the climate control system.

Z (Rear Wiper): Press to turn the
rear wiper on and off. The wiper
speed cannot be changed.

Y (Wash): Press to spray washer
fluid on the rear window. The
window wiper will also come on.
Release the button when enough
fluid has been sprayed on the
window. The rear wiper will run a
few more cycles after it is released.
If the rear wiper function was
already on, prior to pressing the
wash button, it stays on until the
wiper button is pressed again.

The rear window washer uses the
same fluid that is in the windshield
washer reservoir. See Washer Fluid
on page 10‑23
.

Compass

Your vehicle may have a compass
in the Driver Information Center
(DIC). See Driver Information
Center (DIC) on page 5‑26
for
more information about the DIC.

Compass Zone

The zone is set to zone eight upon
leaving the factory. Your dealer will
set the correct zone for your
location.

Under certain circumstances,
such as during a long distance
cross-country trip or moving to a
new state or province, it will be
necessary to compensate for
compass variance by resetting the
zone through the DIC if the zone is
not set correctly.

Advertising