MBW GPR135 - Manual (Page 21)

- 18 -
5. Remove electrical tape from positive battery cable
(#11) and assemble to engine starter.
6. Remove electrical tape from negative battery cable
(#10) and assemble under head of engine mounting
bolt (#29).
7. Secure engine ignition box to mounting bracket (#14)
using three 6mm bolts (#35).
Refer to Main Assembly, page 22.
8. Assemble rollcage (#20) to engine deck (#21) with
four hex head cap screws (#30), washers (#35) and
lock nuts (#31).
9. Using main lift hook on roll cage, lower engine deck
assembly onto baseplate. Use care to route hydraulic
hose through engine deck and up handle tube.
10. Install four bolts (#33) lockwashers (#35) and
washers (#36) through engine deck into
shockmounts on bottom plate.
Refer to engine pages (Gasoline or Diesel)
11. Slide belt (#3 or #4) onto clutch (#4 of #7).
12. Refer to the Belt Adjustment section of this manual
to complete assembly.
13. Secure hydraulic line (#21) to control head fitting.
14. Bleed the hydraulics according to the Bleeding and
Adjustment of Hydraulic Controls section of this
Manual.
Diesel Engine Throttle Adjustment
1. Check to make sure the throttle control lever (#1) is in
the full stop position and the engine throttle arm (#4)
is rotated to the full counter clockwise position. If not
adjust as needed using the threaded portion of the
throttle cable in bracket (#5) then tighten jam nuts
(#6) after final adjustment.
2. Push throttle control lever (#1) forward to full throttle
position (do not force). While holding lever in this po-
sition screw in throttle stop set screw (#2) until you
can feel it touch or start moving the throttle control le-
ver. Assemble and tighten jam nut (#3) to lock this po-
sition.
3. Start unit up and test for full throttle operation and
shut down. Re-adjust as needed, full throttle RPM for
diesel engine is 3600 to 3700, this is not adjustable.
2 3 1
ENGINE VIEW:
4
5
6
FIGURE 6