Lukas LSI 55 - Manual (Page 10)

10
Before connecting, withdraw and hold the locking socket (position X). Connect the nipple
and socket and release the locking socket. Then turn the locking cover to position Y.
The connection has now been made and secured. Decoupling is carried out in reverse.
It is only possible to connect the device if the hoses are depressurised.
The supplied dust covers are used to protect against dust.
Attention!
The quick couplings currently have a special function therefore must not be unscrewed
from the hose lines and/or replaced!
7.3 Electrical (only cutters with electric controls)
The device has an approx,. 0.5 m electrical cable with a plug. This plug is connected
with the coupling of the electrical power cable and in parallel with the hose line pair
from the pump engine.
7.4 Mechanical (only cutters with cylinder bottom)
When using the cutter in a manipulator, important principles must be observed in
order to exclude danger to life and limb and to the device:
- The device must be freely rotatable around its long axis (possible through axis
on the robot or corresponding rotor hub / LUKAS accessories) for vertical
positioning to the cut material.
- The addition of protective covers and/or measures for switch securing (e.g.
safety light barrier) must be ensured.
Important!
In any case, installation must be agreed technically and in terms of safety with LUKAS!
7.5 Mechanical fixing on a balancer from the LUKAS accessories
(only cutters with 4/3-way valve or electric controls)
First setup the weight of the cutter on the
green swivel (see arrow on the picture left)
on the reverse of the balancer, this
guarantees that the cutter will remain
hanging at any desired height.
Fix the balancer to the intended suspension
(e. g. arm hook) by using the attached hook
(see picture right, pos. 1).
1