Lukas LSI 55 - Manual (Page 4)

4
2.6 The operating pressure marked on the device must not be exceeded.
2.7 Only original LUKAS parts and original LUKAS accessories and system
components should be used for repairs.
2.8 Prescribed and named deadlines for tests/inspections as stated in the operating
instructions must be observed.
2.9 Properly dispose of all packaging materials and removed parts.
3 General safety instructions
3.1 In the event of a malfunction, immediately shut off and secure the device. Repair
(arrange repair) immediately.
3.2 Before start-up / running and during operation, ensure that nobody can be
endangered by the running device. This also means checking the device for loose
connections.
3.3 Do never grip between the blades and take care that body parts (e. g. hair, fingers)
or clothing are never insert between openly visible movable parts.
3.4 Only touch the cutting parts with protective gloves as cutting edges are very sharp.
3.5 Please note that cut material can fall or catapult away as a result of its sudden
removal and suitable protective measures should be taken.
3.6 When working, you must ensure there is sufficient illumination.
3.7 After each use of the device, check for external damage and deficiencies.
Immediately report changes detected (including changes to its operation) to the
appropriate office. If necessary, immediately shut off and secure the device. Check
all hydraulic and electrical lines, hoses and threaded connections for leakage and
check for external damage and immediately repair. Leaking oil can lead to injuries
and fires. Damaged electrical lines can lead to short circuits and electric shocks
which can result in death.
3.8 All types of work which affect the safety and stability of the device are prohibited.
Damage can also occur as a result of the device falling over and/or persons can be
injured by the falling device. Take care if you use a balancer that in case of a
malfunction there is also the possibility that the device could fall down.
3.9 You must check that all safety equipment is complete and in perfect condition:
- Labels and notices (safety notices)
- Safety covers (e.g. hand guard, etc.) are on and in perfect condition.
3.10 When working near energised components and lines, suitable measures
should be taken to avoid current transfers or high voltage transfers to the device.
3.11 The device is filled with hydraulic fluid. These hydraulic fluids can affect your
health if drunk or if their fumes are inhaled. Direct skin contact should be avoided for
this reason. When working with hydraulic fluids, please be aware that they can have
a negative impact on biological systems.