Lukas LSI 55 - Manual (Page 11)

11
Then fix the LSI cutter to the swivel hanger (see
picture left).
Note:
The device cannot be clamped tighter in
the hanger! This is because the cutter is
pivoted in the swivel hanger.
The swivel hanger has 2 holes in order to equalise
differences in center of gravity (see picture left, pos.
2) by fixing the clevis into the second hole
.
The LSI cutter should now be hanging
vertically aligned to the steel cable (see
picture right).
Unlock the balancer by pulling out the
spring bolt (see picture left, pos. 3) and
turning it counterclockwise to the se-
cond, slightly higher positioned catch
and release the spring bolt to snap in.
8 Operation
8.1 Initial operation
Before first starting up, check the device for external, apparent damages and deficiencies!
Check all lines, hoses and screwed connections for leakages and external damages.
Before connecting the LSI-cutter, check the pump intended for use (see the separate
operating instructions for the pump).
Before the first starting up and after repairs, the device must be ventilated:
-
Connect device to the hydraulic pump (see „Connecting the device“)
- Fully open the device twice without load until the blades can no longer move, then
immediately switch to idle and immediately close to approx. 2 mm.
2
3
Catch:
extraction
locked Catch:
extraction
unlocked