Lukas LSI 55 - Manual (Page 5)

5
3.12 The generation of an electrostatic charge producing sparks as a possible
consequence should be avoided when working with the device.
3.13 When working with or storing the device, ensure that the function and safety of
the device are not affected by large external temperature effects and that it is not
damaged. Please note that the device can heat up as a result of prolonged use.
3.14 Safety equipment must never be disconnected.
3.15 Never work when overtired or inebriated.
3.16 Before transporting the device, always check that the accessories are secure.
3.17 Make sure that you do not caught by hose lines and cables and trip when using
or transporting the device.
4 Maintenance and servicing instructions
4.1 In order to carry out maintenance and service work, equipment suitable for the
work is required. Only staff with specific knowledge and experience in hydraulics may
work on the device!
4.2 Clean oil and all dirt from device and, in particular, connections and screw joints
before starting working. Do not use an aggressive detergents. Use a fibre-free cloth
and ensure thorough cleanliness, especially when rebuilding.
4.3 When dismantling the device, ensure that all escaping hydraulic fluid is collected,
that it does not enter the soil and that it is disposed of in accordance with existing
provisions.
4.4 Always tighten loosened screws and threaded connections when assembling
and observe the prescribed torque.
4.5 Work on electrical devices may only be undertaken by a specialist electrician or
by trained persons under the supervision of a specialist electrician corresponding to
the electrical technical regulations.
4.6 Aggressive media (acids, soaps, solvents, steam) can damage the device. If the
device has to be operated in such an environment in exceptional cases, or if it comes
into contact with such items, the entire device must be thoroughly cleaned. Moreover,
a check according to No. 3.7 above must be undertaken.
4.7 LSI tools must be inspected at regular intervals for dirt in the hand guard, notably
when working overhead. This dirt must immediately be removed (see also
„Maintenance).
4.8 The electrical equipment of the device must regularly be inspected/checked.
Deficiencies, such as loose connections and braised cables, must immediately be
remedied.