Lukas AHP2-1D - Manual (Page 13)

13
COD. 193553058 - v.2 - UPD 060404
Fig.12
Filler and breather plug
“Double acting” connection
for drain into reservoir
Treadle
Compressed air inlet connection
Pedal locking pushbutton
Pump body/reservoir
Breather screw
Hydraulic pressure
hose ports
Fig. 12 shows the pump with 2.5 litre reservoir
GENERAL PRECA GENERAL PRECA GENERAL PRECA GENERAL PRECA GENERAL PRECAUTIONS UTIONS UTIONS UTIONS UTIONS
This manual contains important safety information: read carefully before installing and using the pump.
This manual must always accompany both the pump and the machine on which the pump is installed, even when
pump and machine or the pump alone is sold, loaned or otherwise transferred to other premises. Before installing the
pump and setting it up for operation make sure it has not been damaged during transportation: check that there are no
cracks or dents on the body and that there are no traces of oil leaks. If damage is noticed, inform the carrier of the
problem immediately. DO NOT INSTALL THE PUMP. Ask the manufacturer for instructions.
The manufacturer shall not be held liable for injury to people or animals or
damage to property caused by installation and operation of a damaged pump.
1 - TRANSPOR 1 - TRANSPOR 1 - TRANSPOR 1 - TRANSPOR 1 - TRANSPORTTTTT, ST , ST , ST , ST , STORA ORA ORA ORA ORAGE AND UNP GE AND UNP GE AND UNP GE AND UNP GE AND UNPA A A A ACKING CKING CKING CKING CKING
Given the modest weight of the pump, no particular transport precautions are necessary.
Is the pump set aside for use some time after the date of purchase, it must be stored in a place that is adequately
protected against the weather at a temperature between 10° and 50° C.
Given the structure of the pump and its packaging, a maximum of 4 single boxes can be stacked one on top of the
other. If the pumps are delivered packed on pallets, they should be left in their original packing and unpacked
immediately prior to installation.
Dispose of packing materials in accordance with the prescriptions of the law in the country in which the pump is
unpacked.
2 - DESCRIPTION 2 - DESCRIPTION 2 - DESCRIPTION 2 - DESCRIPTION 2 - DESCRIPTION
The device supplied is an air-powered hydraulic pump that converts a compressed air supply into a pressurized
hydraulic flow (see “Technical specifications” Chapter 4).
The pump can be utilized to directly power single and double acting hydraulic devices.
All other uses of the pump shall be considered improper and can cause serious
accidents. The manufacturer declines all liability for damages resulting from
improper use of the pump.
Ask the manufacturer if in doubt about the correct installation or use of the pump.
Figure 12 shows the components of the pump.
Directional control valve