Synergy 5221-A - 2011+ Jeep JK 2/4 Door Front Cage Kit - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5221-A JK 2 & 4 DOOR THRU DASH FRONT
CAGE KIT (2011- Present Models)
Version 1.1
GENERAL NOTES:
These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
This is a weld in roll cage kit; all welding should be performed by an experienced
welder with proper welding equipment.
This kit requires cutting and fitting of the dash. Thoroughly read through all
instructions before beginning.
Use in conjunction with PPM-5222; 2 dr rear cage kit or PPM-5224; 4 dr rear
cage kit. Additionally, kit can be used in conjunction with 5223 4 dr B-pillar tie
in kit on 4 dr models.
This kit works with either a soft top or hard top
Use extreme care when welding and grinding in the interior of your Jeep, remove
or cover any components you do not want welding spatter or grinding sparks to
damage.
1. Remove the hard top or soft top. If using a soft top, remove the door surrounds.
2. Remove the sound bar, sun visors, front upper corner trim, and windshield support
bar padding.
We recommend, although it is not necessary, to remove both front seats
of the Jeep, along with all interior carpet from the front seats forward.
This will be covered in detail later.
3. Position the new B-pillar cross bar bracket on the rectangular shaped B-pillar. The
triangle points forward so the holes in the bracket and in the B-pillar are aligned.