Bell'O 8335 - Manual (Page 17)

Figure 13
WP
U
T
Concrete
After you have prepared the holes for mounting the Wall Plate (WP), install the wall plate
by inserting the four (or six) Lag Bolts (T) through the mount and into the
ALLIGATOR ® Anchors (U) as shown in Figures 10 and 13. After checking that the
wall mount is level, tighten all lag bolts fully, but be careful not to over-tighten.
English
3" (76mm)
minimum hole depth
Installing the decorative End Covers
Figure 14
WP
EC
Even though your TV hides most
of your wall mount from view,
from the sides you can probably
still see the ends of the bracket.
This kit includes decorative End
Covers (EC) to make your bracket
installation look clean and
finished. To install the end covers,
simply line up the cover with the
end of the bracket, and press into
place. Look for two holes in the
frame of the bracket which the
end cover inserts into, as shown in
Figure 14.