Locking the arms into place, Using the tilting arm feature, English – Bell'O 8335 User Manual

Page 20

Advertising
background image

Locking the arms into place

After the TV with the Monitor Arms (MA) is positioned on the Wall Plate (WP), you

need to lock the arms into place so that the TV cannot inadvertently come off the wall

plate or be removed. To lock the arms, simply turn the large screw head on the side of

both of the bracket’s locking mechanisms 90° toward the wall using a screwdriver as

your assistant holds the TV in place. (See Figure 17.) After you’ve done this, and the

locking mechanism has been engaged, tighten the M4 x 10mm Security Screw (AB)

behind the large lock screw to prevent the locking bar from rotating out of the locked

position. Repeat this procedure on both sides of the bracket. For extra security, in

addition to the security screw, you can also place a padlock through the large holes in

the protruding tabs of the locking mechanism.

Large

Screw Head

AB

Locking Bar

Shown Down in

Locked Position

To

Lock

Figure 17

After the TV is

installed, carefully

try to lift it off to

make sure it is

secure. If it is

correctly secured,

the TV should

not move.

Using the tilting arm feature

After you’ve securely locked the TV with the monitor arms securely onto the wall

plate, you can safely adjust the tilting feature on the arms. The arms can tilt up to 15°

downward or up to 5° upward, depending on your optimum viewing position. Have

your assistant hold the TV steady before you start to adjust the tilt. To adjust the tilt of

your TV, simply reach behind the TV and turn the lever in the center of the arm to

loosen. It works like a ratchet so that you can loosen the lever easily in a very confined

area. To disengage the lever, rotate it away from the monitor arm and reposition as

shown in Figure 19. Push it in again to turn and adjust the arm’s tension as shown in

Figure 18. Repeat this procedure for the lever on the other arm also before attempting

to position the TV.

After the TV is in the desired tilted position, you need to tighten the levers. Turn the

levers clockwise to tighten, pulling out to disengage the rachet mechanism.

English

Advertising