Bell'O 8335 - Manual (Page 9)

English
Choosing which screws to use for your TV
You’re probably wondering why so many screws came with this mount. The screw sizes
follow the standards setup by VESA for each mounting configuration.
Most monitors have the mounting holes flush with the back of the monitor. If yours is
like this, you likely need to use short screws. Test several of the screws included in this
kit to find the correct match for the holes in the back of your TV.
Don’t use screws that are too long because they will not fully seat in the holes
and can permanently damage the TV or mounting holes and cause the monitor
to come loose.
R or S
Selected Screw
DETAILED VIEW
Back
of TV
Figure 3
MA
Attaching the Monitor Arms
After you’ve figured out which screws to use for your TV, attach each Monitor Arm
(MA) to the back of the TV as shown in Figures 3 and 4. Make sure that the arms are
oriented properly, with the adjustment levers facing toward the outer edge of the TV so
that you can reach them later.
Also make sure that each Washer (R for M4 or M5 screws, or S for M6 or M8 screws)
is placed between the screw and the monitor arm. Don’t place the washers between the
arms and the TV.