Snorkel TB85J Fixed Axle CE - Manual (Page 31)

TB80/TB85J Fixed Axle – 0112823EE 27
Potential service and safety problems may be detected
by inspecting the aerial platform. This chapter includes
information on properly inspecting the aerial platform and
includes a prestart inspection check list at the end of the
chapter to ensure that no areas are overlooked.
A
Warning
The potential for an accident increases when oper-
ating an aerial platform that is damaged or mal-
functioning. Death or serious injury can result from
such accidents. Do not operate the aerial platform
if it is damaged or malfunctioning.
Perform a prestart inspection at the beginning of each
shift, before using the aerial platform on the job. The in-
spection site must have a smooth and level surface.
Operator’s Manual
The manual holder is located behind the right rear cowl-
ing door (refer to Figure 7.1). Make certain it is securely
fastened in place.
Figure 7.1 – Operator’s Manual Holder
Check to see that the proper Operator’s Manual is in the
holder. The manual should be complete with all pages
intact and in readable condition.
Engine
Open the engine compartment doors on both sides of the
machine and visually inspect the engine and its compo-
nents with the engine off.
Oil Level
Check the engine oil level before starting the engine so
the oil has drained to the pan. The proper oil level is be-
tween the add and full marks on the dipstick.
The distance between the top and bottom dipstick marks
corresponds to about 1 liter (1 quart US). Add oil, if nec-
essary, before starting the engine.
Chapter 7 – Prestart Inspection
Coolant
Cummins and GM engines are liquid cooled. When the
engine is cold, there should be about 2.5 cm (1
″
) of cool-
ant in the bottom of the reservoir (refer to Figure 7.2).
Figure 7.2 – Coolant Reservoir
A
Caution
Engine coolant escaping under pressure can cause
serious burns. Shut the engine off and let it cool
before removing the radiator cap.
Add coolant, if necessary, when the engine is cold and
not running. When running at operating temperature the
coolant should be at the hot level.
Deutz engines are air cooled. Visually inspect the air
intake and fan (refer to Figure 7.3) to be sure they are
free of obstructions that could stop or slow the flow of air.
Inspect the fan belt to see that it is in place and not
cracked.
Figure 7.3 – Deutz Air Intake
Radiator
Inspect the radiator hoses and clamps for wear, leakage,
or damage. Make sure the hoses are not hardened,
cracked, or feel spongy. Make sure the cap is in place
and tight.
Fan
Fan Belt
Coolant Reservoir
Operator’s Manual Holder