Snorkel TB85J Fixed Axle CE - Manual (Page 36)

Chapter 7 – Prestart Inspection
32 TB80/TB85J Fixed Axle – 0112823EE
Figure 7.14 – Level Sensor
5. Pull the level sensor to the side as far as possible to
activate the tilt alarm.
A
Warning
The potential for an accident increases when safety
devices do not function properly. Death or serious
injury can result from such accidents. Do not alter,
disable, or override any safety device.
6. If the alarm does not sound, remove the machine
from service until the problem is corrected.
7. Lower the main boom.
Flashing Light
If the machine is equipped with an optional flashing light,
visually check to see that it flashes. The light should
flash when the engine is running.
Sandblast Protection Kit
The optional sandblast protection kit protects the cylin-
ders from abrasion while sandblasting or from paint
overspray. Rubber covers protect each cylinder rod as it
extends and retracts. The covers prevent sand and paint
from damaging the cylinder seals and rod.
Inspect the covers while operating the machine to ensure
they are securely fastened and completely cover the cyl-
inder rod. Make sure there are no holes in the covers.
Structures
Visually inspect all weldments and related components.
It is important to inspect the fasteners that connect the
components.
Weldments
Visually inspect all weldments for abnormal wear, abra-
sion, or deformation that could cause interference be-
tween moving parts.
Inspect the welds on the structural components. Pay
particular attention to boom welds. The area to be in-
spected should be clean and free of dirt and grease. Look
for visible cracks in the weld and at the weld to parent
material joint. A bright light may be used to provide ad-
equate visibility of the inspection area.
Slide Pads
The main boom has slide pads (refer to Figure 7.15) be-
tween the main and tip boom sections.
Figure 7.15 – Slide Pads at Tip End of Boom
Use the lower controls to raise the main boom to hori-
zontal. Extend the tip boom about 30 cm (1
′
). Visually
inspect the slide pads to make sure they are in place
and are not obviously loose.
Inspect the surface where the pads contact the interme-
diate and tip booms. The paint must be in place with no
signs of bare metal.
The extension cylinder support bracket has slide pads
(refer to Figure 7.16) that can be inspected by looking
into the base end of the main boom.
Figure 7.16 – Extension Cylinder Support Bracket
Level Sensor
Slide Pads Slide Pads
Slide Pads
Wire Ropes