Behringer Eurolight 24-Channel DMX Lighting Console LC2412 - Manual (Page 6)

6 EUROLIGHT LC2412 User Manual
(1)
(2)
(4)
(10) (11) (5)
(3) (8) (9) (6) (7)
Fig. 2.1: Section overview
2.1 Control elements of the A PRESET section
(12)
(33)
Fig. 2.2: A PRESET section (detail)
(12) Faders 1-12. Used to set the intensity of light elements connected to the
dimmer pack.
(33) UPPER switch. When you press this switch, the A PRESET section is switched
to the twelve additional channels. After that, you can set up the intensity of
channels 13 - 24. See also chapter 3.2.
Setting up presets
Channel faders are used for setting up a preset that can be directly recalled by
moving fader A (41). As in all other setups, the MAIN fader (43) (see chapter 2.6)
determines the maximum illumination level of selected light sources.
2.2 Control elements of the B MEMORY
section ( 2 )
The faders of the B MEMORY section are located in the block underneath the
A PRESET section.
(13) These faders control the illumination level of an entire group of channels
in a ratio to one another that you previously determined by setting up the
A PRESET faders and saving this setting as a memory.
(13) (14) (15) (16) (17)
(18)
(20)
(19)
(21)
Fig. 2.3: B MEMORY section