BURY CC 9048 USER Manual - Manual (Page 13)

12
Operating guidelines
6. Language selection
After properly connecting the HFCK to the power supply, the device will start with the launch of the car
ignition. To use voice prompts, activate them by pressing and holding the Plus button for 10 seconds.
Then select the language for voice prompts after the device informs about it by emitting “select lan-
guage”. Available languages will be read out (English, German, French, Spanish, Russian, Polish, Czech
and Dutch), a single press of the middle button during wanted language presentation confirms the
choice. The list of available languages will be read three times, in the absence of selection, English will
be loaded automatically.
To change the language selection, restore the factory settings by holding the Minus button for
10 seconds. The device will reset, then the voice prompts have to be activated and the system will
repeat the procedure of language selection from the beginning.
To turn off the voice prompts just press and hold the Plus button for 10 seconds.
7. Establishing a Bluetooth connection
If you wish to establish a Bluetooth connection for the first time, you have to activate the Bluetooth
function of your mobile phone and search for
Bluetooth devices. In this case, search for a device la-
belled “CC 9048...”.If several devices were identified, please select the HFCK and enter the PIN
number “1234”. The Bluetooth connection (pairing) will then be established between your mobile
phone and the HFCK. It is possible that you will also have to click on ‘connect’ or ‘allow data transfer’
on your mobile phone if you want to be able to make a connection.
Please note:
Searching for X Bluetooth devices and establishing a Bluetooth connection may take
2-3 minutes.
If it is not possible to establish a connection, please check and update the software release (firmware)
of your mobile phone or of the HFCK. You will find an overview dealing with this subject on the Internet
at www.bury.com.
Note:
In the internet you can find an overview with a large number of mobile telephones which X
have been tested with this hands-free car kit. Please note, however, the use of firmware which
deviates from the list and is installed on a listed mobile telephone can lead to the fact that
certain displays and functions are no longer possible or only possible to a limited extent.
In addition it is possible that you must delete all devices connected to your mobile phone first in
order to enable a correct identification of the HFCK and the establishment of a connection. If you
have queries regarding the menu navigation, functions and operation of your mobile phone,
please refer to the operating guidelines of your mobile phone. Depending on the manufacturer
and type, this can differ considerably between phones.