BURY CC 9048 USER Manual - Manual (Page 7)

6
Installation of the hands-free car kit
4. Positioning and installation
Step 1:
First of all, choose the most suitable location for the illuminated remote
control by positioning it or holding it at different locations in the vehicle
yourself. Once you have found a suitable position for the illuminated
remote control, you can attach it / mount it appropriately. Please use
the cleaning cloth provided to remove any grease or dirt from the sur-
faces. Please remember that in the event of strong temperature varia-
tions, depending on the structure and quality, the colours of the sur-
faces may fade during subsequent use.
Important:
The remote control can only be stuck down once. Damage X
to its adhesive surface may occur when it is removed.
Step 2:
Depending on the vehicle type and its equipment (e.g. airbags), it is
reasonable to install the microphone either at the A-pillar, at the sun
shield or at the roof interior. For details about the equipment features
please refer to the vehicle documents.
Step 3:
Please lay the cables in a way that they do not lie/hang unsecured in
the vehicle and that they may not influence the conducting of the vehi-
cle. When laying a cable, please take care that it is not under traction
stress but that it has some tolerance. Avoid crushing the cable as dam-
ages of the insulation can be caused by friction/rubbing.
Step 4:
Install the electronics box at a convenient place in the vehicle. This can
e.g. be behind the radio, in the glove box, or in the centre console.
Please mind that you can access the connections of the box without
difficulty. Before connecting the components to the electronics box you
should branch off the battery for safety reasons. In doing so, take into
account that there might be a radio coding (confer radio manual).
Important:
Please install the electronics box behind a cover or some- X
where you can only reach by opening or unfastening a pro-
tective cover / a cover. The terminal box must not hang
loosely in the vehicle.